1. Is the LED brightness acceptable when set to low brightness mode?
Context: The LED should dim appropriately to avoid glare in dark environments.
2. Was the protection LED delayed, potentially confusing users?
Context: The protection LED should activate immediately to signal system faults.
3. Did the amp unmute successfully when the volume up or down button was pressed?
Context: The amp should unmute instantly to reflect user input accurately.
4. Did the TV remain muted after 30 seconds of activating the mute command?
Context: The TV should maintain mute status until unmuted by the user.
5. Was the remote successfully programmed to control the amp's power ON/OFF?
Context: The remote should power the amp on and off without issues.
6. Did the amp switch inputs correctly when testing the dual-source switchover?
Context: The amp should seamlessly switch inputs between sources.
7. Were there any issues observed during rapid DSP EQ frequency adjustments?
Context: The DSP EQ should respond smoothly without glitches when adjusting frequencies rapidly.
8. Did the amp reset to factory defaults successfully?
Context: The amp should reset to factory settings without errors when prompted.
1. Is the LED brightness acceptable in low brightness mode?
Context: The NARC LED should dim to prevent excessive brightness in dark environments.
2. Was the protection LED delayed, potentially confusing users?
Context: The protection LED should illuminate instantly if a system fault is detected.
3. Did the mute command stay active after 30 seconds?
Context: Mute should remain active until unmuted manually by the user.
4. Was the remote successfully programmed to control the amp's power ON/OFF?
Context: The remote should reliably power the amp on and off without errors.
5. Did the amp switch inputs correctly during dual-source switchover?
Context: The amp should switch between input sources without interruption.
6. Were there any issues observed during rapid DSP EQ frequency adjustments?
Context: The DSP EQ should not experience lag during frequency adjustments.
7. Did the amp reset to factory defaults successfully?
Context: The amp should reset to factory settings without failure.